An administrator has a standalone vSphere 8.0 Update 1a deployment that is running with VMware NSX
4.1.0.2 and has to converge the deployment into a new VMware Cloud Foundation (VCF) instance. How can the administrator accomplish this task?

• A. Use the VCF Installer to converge the existing vSphere 8 and NSX 4 environment into a new VCF management domain. Then use the VCF lifecycle management tools to upgrade to 9.
• B. Manually upgrade both vSphere and NSX to version 9 prior to converging. Then use the VCF Installer to converge the vSphere 9 and NSX 9 instances into a new VCF management domain.
• C. Manually upgrade vSphere to version 9. Then use the VCF Installer to converge the vSphere 9 environment into a new VCF management domain. Then use the VCF lifecycle management tools to upgrade NSX to version 9.
• D. Manually upgrade vSphere to version 9 and uninstall NSX 4. Then use the VCF Installer to converge the vSphere 9.0 environment into a new VCF management domain at which time NSX 9 will be reinstalled.

An administrator must prevent a new VPC from exporting any of its prefixes to the datacenter while still receiving a default route. Where should the routing policy be applied?

• A. On the providers' BGP peer template
• B. On the VPC Gateway Firewall
• C. On the VPC default route advertiser
• D. On the VPC's Transit Gateway

An administrator is tasked to create a development environment with a Tier-1 gateway to host overlay segments for only East/West workload communication. North/South communication is also required. The solution will not include the following services: NAT, DHCP, VPN. Which step must the administrator take when creating the Tier-1 gateway?

• A. Assign the Tier-1 gateway to an Edge Cluster before any segments are created.
• B. Configure a Service Interface on the Tier-1 gateway to connect each overlay segment to provide the East
  /West communication.
• C. Keep route advertisement disabled and leave the Tier-1 gateway disconnected from any Tier-0 gateway.
• D. Enable route advertisement and connect the Tier-1 gateway to the Tier-0 gateway.

An administrator is tasked to enable users to configure an individual VPC, but not create subnets. What three NSX roles would the administrator assign to allow access without the ability to create subnets? (Choose three.)

• A. VPC Admin
• B. Network Admin
• C. Security Admin
• D. Security Operator
• E. Network Operator

An administrator is troubleshooting intermittent connectivity failures between two workloads connected to NSX VLAN segments using Traceflow. In-band Network Telemetry (INT) has been enabled in the NSX Global Configuration. How does Traceflow identify issues in a VLAN network?

• A. Compares intended network state in the control plane with Tunnel End Point (TEP) keepalives in the data plane.
• B. Injects ICMP traffic into the data plane and observes the results in the control plane.
• C. Traceflow cannot be enabled to analyze VLAN network segments in NSX.
• D. Injects synthetic traffic into the data plane and observes the results in the control plane.