최신Alcatel-Lucent Services Architecture - 4A0-104무료샘플문제

A. An IES must have at least one SAP defined.

B. An IES service must use static routes to communicate with customer networks.

C. A virtual route table must be configured for an IES service.

D. An IES requires a spoke SDP.

A. It drops the frame.

B. It floods the frame to all PEs participating in the service.

C. It sends the frame to the closest neighbor.

D. It sends a destination unreachable message back to the originating host.

A. A SAP can only be created on a port configured as "access".

B. A SAP is the subscriber's point of entry to the service network.

C. A SAP is created by specifying a physical port and an encapsulation type.

D. A SAP can be associated with more than one service.

A. TRUE

B. FALSE

A. A virtual routing/forwarding table is created per IES service.

B. An IES supports QoS.

C. An IES interface's IP address, if bound to a port, will appear in the routing table.

D. An IES provides a Layer 3 interface to a customer.

A. Customer ID

B. Service ID

C. VC-ID

D. SDPID

E. SAPID

A. A-pipe

B. C-pipe

C. F-pipe

D. E-pipe

E. I-pipe

A. config>service# epipe service-id no shutdown

B. config>service# service-id no shutdown

C. config>port# port-id no shutdown

D. config>service# vpws service-id enable

E. config>service# epipe service-id enable

A. An echo request is sent based on the LSP's label stack.

B. Echo reply packets may not take the same path as the LSP.

C. The test fails if the LSP is not operationally up.

D. The IP destination address is used to initiate echo requests,

A. The service ID is added as the VLAN tag.

B. The frame is forwarded with no VLAN tag

C. The frame is dropped.

D. A VLAN tag of 0 is added as the provider VLAN tag