최신API Source Inspector Electrical Equipment - API-SIEE무료샘플문제

A. Process skids cannot include instrumentation wiring

B. Hazardous-area certification is not required for field devices

C. Most electrical and control equipment is often located off-skid in an unclassified location

D. All electrical and control equipment is normally mounted directly on the skid

A. vars.

B. volt-amperes.

C. watts.

D. mhos.

A. complete test.

B. design test.

C. compliance test.

D. routine test.

A. on the wireway to prevent opening the wireway on the motor control center.

B. on the rear door of the low voltage motor control center.

C. on the door to prevent opening the combination starter door.

D. on the external operating handle.

A. Master Scheduler

B. The inspection coordinator

C. The shop QA Manager

D. Project Manager

A. Class I Zone 1.

B. Class I Zone 2.

C. Class I Division 2.

D. Class I Zone 0.

A. Manufacturing Engineer

B. Vendor's Quality Manager

C. Source Inspector

D. Inspection Coordinator

A. Reissue of procurement bid tabs

B. Reclassification of the project risk register

C. Elimination of all documentation requirements

D. Verification that all FAT issues are resolved

A. Manufacturing Standards

B. Client Standards

C. Supplier Quality Standards

D. Material Test Reports

A. Mounting bolt torque is verified with a calibrated torque wrench with no visible gaps observed between the foot and base interface

B. A dial indicator is oriented vertically and zeroed prior to base bolt tightening with a reading taken after tightening to confirm movement is within tolerance

C. After torquing mounting bolts, a vertically oriented, zeroed, dial indicator is attached to each foot and a reading taken after loosening of the bolt torque to verify movement is within tolerance

D. Feeler gauges are used at the foot to base interface to verify gap tolerance has not been exceeded