2026년에는 기다리는 시간마저 아끼시기 바랍니다. KoreaDumps의 F5CAB1 자료는 결제 후 1분 이내에 이메일로 도착하며 72문항 전체를 곧바로 시작하실 수 있습니다.

F5 F5CAB1 시험 개요:

F5 F5CAB1 시험 요강 주제:

F5 BIG-IP Administration Install, Initial Configuration, and Upgrade에 대해 알아야 할 모든 것

최신 F5-CA F5CAB1 무료샘플문제

문제 #1

What is the purpose of a Virtual Server in BIG-IP?

A. It is used to configure the Self-IP
B. It defines a failover mechanism for the system
C. It defines how SSL certificates are managed
D. It handles the routing of traffic to back-end servers

문제 #2

The Configuration Utility of a BIG-IP device is currently accessible via its management IP
10.53.1.245 from all VLANs.
The BIG-IP Administrator needs to restrict access so only hosts from the 10.0.0.0/24 subnet can access the Configuration Utility.
Which TMSH command accomplishes this?

A. (tmos)# create /net acl MGMT.HTTP rule add { (permit tcp 10.0.0.0/24 10.53.1.245 http) (deny ip any any http) }
B. (tmos)# modify /sys httpd allow replace-all-with {10.0.0.0/24}
C. (tmos)# modify /ltm httpd allow replace-all-with {10.0.0.0/24}
D. (tmos)# create /net acl MGMT.HTTP rule add { (permit tcp 10.0.0.0 0.0.0.255 host 10.53.1.245
http) }

문제 #3

The monitoring team reports that the SNMP server is unable to poll data from a BIG-IP device.

What information will help the BIG-IP Administrator determine whether the issue originates from the BIG-IP system?

A. The "Port Lockdown" setting is preventing the SNMP server from polling data from the BIG-IP.
B. The "Traffic Group" setting must use a floating Traffic Group.
C. The configuration on the exhibit is correct and other options should be explored.
D. The "VLAN / Tunnel" setting must allow All Vlans.

문제 #4

What is the primary function of the Traffic Management Operating System (TMOS) in F5 BIG-IP?

A. It is responsible for system management and operations
B. It provides the hardware resources for the system
C. It encrypts data between servers
D. It allows for traffic routing between the Internet and data center

문제 #5

When using the tmsh shell of a BIG-IP system, which command will display the management-ip address?

A. show /sys management-ip
B. list /sys management-ip
C. run /util bash ifconfig mgmt

질문과 대답: