최신HPE Aruba Networking Switching Professional - HPE7-A08무료샘플문제
문제1
You have created a LAG interface to a Gateway on a VSX pair using the following commands:
interface lag 10
description Gateway
no shutdown
no routing
vlan trunk native 1
vlan trunk allowed all
lacp mode active
After checking the state of the link aggregation group (LAG) on the Gateway, you can see that only one of the member links is up. What is causing this?
You have created a LAG interface to a Gateway on a VSX pair using the following commands:
interface lag 10
description Gateway
no shutdown
no routing
vlan trunk native 1
vlan trunk allowed all
lacp mode active
After checking the state of the link aggregation group (LAG) on the Gateway, you can see that only one of the member links is up. What is causing this?
정답: B
설명: (KoreaDumps 회원만 볼 수 있음)
문제2
What should you configure for an interface connected to a device you cannot trust to assign DSCP markings?
(Select two.)
What should you configure for an interface connected to a device you cannot trust to assign DSCP markings?
(Select two.)
정답: B,E
설명: (KoreaDumps 회원만 볼 수 있음)
문제3
Refer to the exhibit:

Both switches, Core-1 and Core-2, are configured with default spanning-tree priorities. Both switches appear as primary root bridges. What must be done to have only one spanning tree domain?
Refer to the exhibit:

Both switches, Core-1 and Core-2, are configured with default spanning-tree priorities. Both switches appear as primary root bridges. What must be done to have only one spanning tree domain?
정답: A
설명: (KoreaDumps 회원만 볼 수 있음)
문제4
You recently enabled ARP protection on your CX switches, but many users now complain that they can no longer access the network.
What do you need to configure to resolve the issue?
You recently enabled ARP protection on your CX switches, but many users now complain that they can no longer access the network.
What do you need to configure to resolve the issue?
정답: B
설명: (KoreaDumps 회원만 볼 수 있음)
문제5
You are reviewing the configuration of a VSX LAG and have noticed the command LACP fallback. Why might this have been configured?
You are reviewing the configuration of a VSX LAG and have noticed the command LACP fallback. Why might this have been configured?
정답: B
설명: (KoreaDumps 회원만 볼 수 있음)
문제6
What does it mean when an event such as the one below occurs on the HPE Aruba Networking CX switch?
2024-04-04T08:35:36.312254+00:00 ICX-Core-1 hpe-vsxd[2167]: Event|7012|LOG_INFO|AMM|1/1|VSX 2 state local down, remote up
What does it mean when an event such as the one below occurs on the HPE Aruba Networking CX switch?
2024-04-04T08:35:36.312254+00:00 ICX-Core-1 hpe-vsxd[2167]: Event|7012|LOG_INFO|AMM|1/1|VSX 2 state local down, remote up
정답: D
설명: (KoreaDumps 회원만 볼 수 있음)