최신Juniper Enterprise Routing and Switching, Specialist (JNCIS-ENT) - JN0-352무료샘플문제

A. GRE adds 12 bytes of overhead to each packet.

B. GRE adds 32 bytes of overhead to each packet.

C. GRE adds 20 bytes of overhead to each packet.

D. GRE adds 24 bytes of overhead to each packet.

A. Enable the passive option on the OSPF interfaces that are connected to the Dallas and Denver subnets.

B. Create static routes on the switches using the local vMX router's loopback interface for the next hop.

C. Configure and apply a routing policy that redistributes the Dallas and Denver subnets using Type
5 LSAs.

D. Configure and apply a routing policy that redistributes the connected Dallas and Denver subnets.

A. 10 seconds

B. 90 seconds

C. 60 seconds

D. 30 seconds

A. Create a default generate route that includes an import policy to match BGP routes from ISP1 and assign a preference value of four or less.

B. Create a default aggregated route.

C. Create a default static route with each neighbor address as the next hop.

D. Create a default static route with ISP1's address as the next hop while specifying the addresses for ISP2 and ISP3 as qualified next hops with a preference value of six or higher.

A. By default, the violation will automatically be cleared after 300 seconds and the interface will resume sending and receiving traffic for all learned devices.

B. By default, you must manually clear the violation for the interface to send and receive traffic again.

C. By default, the interface will continue to send and receive traffic for all connected devices after a violation has occurred.

D. By default, devices that are learned before the violation occurs are still allowed to send and receive traffic through the specific interface.

A. The packet is encapsulated unchanged before entering the tunnel.

B. The time-to-live value of the original packet is decremented.

C. IP-IP tunnels are protocol agnostic.

D. The packet header is replaced before entering the tunnel.

A. The ge-0/0/15 interface is using the default port cost.

B. The ge-0/0/9 interface is using the default interface priority value.

C. This switch has a bridge priority of 8k.

D. This switch is currently blocking all traffic.

A. Keepalives must be used on stateless tunneling protocols.

B. BFD must be used on the stateless tunneling protocols.

C. All intermediary devices must have a route to the tunnel endpoints.

D. Tunnel endpoints must have a route that directs traffic into the tunnel.

A. Ensure Switch1 has the lowest bridge priority of all the other switches.

B. Ensure Switch 1 has the highest system MAC address.

C. Ensure Switch1 has the lowest port priority of all other switches.

D. Ensure Switch1 has the highest port costs of all the other switches.

A. R1 will modify the AS path attribute in prefixes advertised to AS 65501

B. R1 will modify the cluster list attribute in prefixes advertised to AS 65501

C. R1 will modify the originator ID attribute in prefixes advertised to AS 65501

D. R1 will modify the next-hop attribute in prefixes advertised to AS 65501

A. GRE tunnels support only IPv4 payload encapsulation.

B. GRE tunnels maintain session state information about the remote endpoint.

C. GRE tunnels need keepalives configured by default to stay operational.

D. GRE tunnels require the tunnel endpoints to have a valid route to each other.

A. The IP source guard is enabled.

B. DHCP snooping is enabled.

C. DHCP snooping is enabled for IPv6 traffic.

D. Dynamic ARP inspection is enabled.

E. The DHCP snooping database is protected.