최신Juniper Service Provider Routing and Switching, Professional (JNCIP-SP) - JN0-660무료샘플문제

A. Configure an export policy on R3 that leaks all IS-IS routes from Level 2 to Level 1.

B. Remove the ignore-attached-bit statement on R4.

C. Configure R3's authentication key to match R4's authentication key.

D. Remove the overload statement on R4.

A. SSM only builds RPT trees, since the RP is replaced by an external mechanism.

B. ASM and SSM for IPv6 multicast use embedded RP.

C. ASM requires an external mechanism to find the source.

D. SSM does not require MSDP.

A. Configure local-preference 10 on R4.

B. Configure router-id 4.4.4.4 on R4.

C. Configure always-compare-med on R2.

D. Configure as-path-prepend on R1 and R3.

A. P1 uses the label value for VPN A advertised by PE1, because RSVP is enabled.

B. PE2 uses the label value received from PE1 for VPN A as the transport label for VPN A.

C. PE1 uses the label value received from PE2 for VPN B as the inner label for VPN B.

D. PE1 uses the transport label value received for VPN A that is advertised by PE2 as the inner label for VPN A.

A. R3 should add the community no-advertise to the route prior to announcing it.

B. R4 should add the community no-announce after receiving the route.

C. R3 should add the community no-export to the route prior to announcing it.

D. R4 should add the community no-advertise after receiving the route.

A. The path selected will be based on the first-hop LSR's RI

B. The path selected will be based on the most-fill bandwidth ratio.

C. The path selected will be based on a randomized algorithm.

D. The path selected will be based on the least-fill bandwidth ratio.

A. Option B

B. Option A

C. Option D

D. Option C

A. Replace the neighbor AS number with the local AS number.

B. Change the maximum number of times an AS can be in an AS path.

C. Set the confederation autonomous system to include private AS number(s).

D. Remove the well-known private AS numbers.

A. IPv4 routes will be exchanged over this session.

B. The local router initiated the BGP session.

C. IPv6 routes will be exchanged over this session.

D. BFD keepalive is configured to 30 seconds.

A. [edit policy-options policy-statement RIP-redist]
user@router# show
term 1 {
from {
protocol rip;
route-filter 50.50.0.0/24 upto /27;
}
then reject;
}
term 2 {
from {
protocol rip;
route-filter 50.50.1.0/24 exact;
}
then accept;
}
term 3 {
from protocol rip;
then accept;
}

B. [edit policy-options policy-statement RIP-redist]
user@router# show
term 1 {
from {
protocol rip;
route-filter 50.50.1.0/24 exact;
}
then accept;
}
term 2 {
from {
protocol rip;
route-filter 50.50.0.0/16 prefix-length-range /24-/26;
}
then reject;
}

C. [edit policy-options policy-statement RIP-redist]
user@router# show
term 1 {
from {
protocol rip;
route-filter 50.50.0.0/16 prefix-length-range /24-/26;
}
then reject;
}
term 2 {
from {
protocol rip;
route-filter 50.50.1.0/24 exact;
}
then accept;
}

D. [edit policy-options policy-statement RIP-redist]
user@router# show
term 1 {
from {
protocol rip;
route-filter 50.50.1.0/24 exact;
}
then accept;
}
term 2 {
from {
protocol rip;
route-filter 50.50.0.0/24 upto /27;
}
then reject;
}
term 3 {
from protocol rip;
then accept;
}

A. Route targets are not properly configured.

B. as-override is not configured in the VRFs.

C. family inet-vpn is not configured on the PEs.

D. No LSP exists between PE1 and PE2.

A. route-distinguisher

B. instance-type vpls

C. site-identifier

D. vpls-id