2026년 Juniper Enterprise Routing and Switching Support, Professional (JNCSP-ENT) 시험을 앞두고 학습 시간 확보가 어려우신가요? KoreaDumps의 JN0-694 연습문제 52문항은 핵심 위주로 구성되어 틈새 시간만으로도 충분히 대비하실 수 있습니다.

Juniper JN0-694 시험 개요:

Juniper JN0-694 시험 요강 주제:

JN0-694 시험 준비, 자주 묻는 질문으로 정리했습니다

최신 JNCSP-ENT JN0-694 무료샘플문제

문제 #1

Your Junos device is dropping certain traffic flows, while allowing other traffic flows to pass
through the device unaffected.
Which CoS component is causing this problem?

A. Rewrite rules
B. RED
C. BA classification
D. MF classification

문제 #2

-- Exhibit - -- Exhibit -

Click the Exhibit button.
Your network has two connections to your ISP. You have been asked to load-balance traffic across both links that connect to your ISP. You have enabled multipath for this peer, but you are still not getting the expected load balancing.
Given the information shown in the exhibit, what else must you do?

A. Create a policy to manually change the next hops.
B. Configure and apply a load-balancing policy.
C. Enable the keep all parameter.
D. Change the multipath parameter to multihop.

문제 #3

You are having problems redistributing RIP routes into OSPF. Your Junos device has the following configuration:
[edit protocols ospf]
user@router# show
import my-policy;
area 0.0.0.0 {
interface ge-0/0/0.0;
interface ge-0/0/ ;
interface ge-0/0/ {
passive;
}
}
What would resolve the problem?

A. Apply my-policy as an export policy under the [edit protocols ospf] hierarchy.
B. Apply my-policy as an import policy under the [edit protocols rip] hierarchy.
C. Apply my-policy as an export policy under the [edit protocols rip] hierarchy.
D. Use the area-range parameter instead of a routing policy.

문제 #4

-- Exhibit - -- Exhibit -

Click the Exhibit button.
On R1, the interface fe-0/0/1 is assigned to the default routing instance and fe-0/0/2 is assigned to a virtual router instance named VR-1.
Referring to the exhibit, the static route 200.200.200.200/32 is missing from the routing table of the default routing instance.
What should you do on R1 to resolve this problem?

A. Change the instance type on VR-1 to forwarding.
B. Configure an import policy to import the route 200.200.200.200/32 to the VR-1 instance.
C. Configure a static ARP entry for address 70.1.1.1.
D. Create a RIB group to import the direct route 70.1.1.0/24 to both the default instance and the VR-1 instance.

문제 #5

-- Exhibit -

-- Exhibit --
Click the Exhibit button.
You are troubleshooting an OSPF adjacency problem between R1 and R2.
Referring to the exhibit, what is causing this OSPF adjacency problem?

A. There is a dead interval mismatch.
B. There is a hello interval mismatch.
C. There is an MTU mismatch.
D. There is an LSA refresh timer mismatch.

질문과 대답: