최신Fortinet NSE 7 - SD-WAN 6.4 - NSE7_SDW-6.4무료샘플문제

A. The traffic shaper limits the bandwidth of each source IP address to a maximum of 625 KB/sec.

B. The number of simultaneous connections allowed for each source IP address can exceed 5 connections.

C. The traffic shaper limits the combined bandwidth of all connections to a maximum of 5 MB/sec.

D. The number of simultaneous connections among all source IP addresses can exceed 5 connections.

A. Both SD-WAN member interfaces have used separate SLA targets.

B. SD-WAN member interfaces are affected by the SLA state of the inactive interface

C. Port1 became dead 1ecause no traffic was offload through the egress of port1.

D. The SLA state of port1 is dead after five unanswered requests by the SLA servers.

A. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.

B. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.

C. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.

D. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.

A. Monitoring links for any bandwidth saturation

B. Processing performance SLA probes

C. Logging interface quality information

D. Flushing route tags addresses

A. SD-WAN rules use SLA targets to check if the preferred members meet the SLA requirements.

B. When configuring an SD-WAN rule, you can select multiple SLA targets of the same performance SLA.

C. SLA targets are used only by SD-WAN rules that are configured with Lowest Cost (SLA) or Maximize Bandwidth (SLA) as strategy.

D. Member metrics are measured only if an SLA target is configured.

A. diagnose sys virtual-wan-link service

B. diagnose debug application ike

C. get router info routing-table

D. get ipsec tunnel list

A. Encapsulating Security Payload (ESP)

B. Transport Layer Security (TLS)

C. Secure Shell (SSH)

D. Internet Key Exchange (IKE)

E. Security Association (SA)

A. twamp

B. smtp

C. udp-echo

D. tcp-echo

E. icmp

A. FortiManager registers FortiGate after the restart and retrieves the existing configuration

B. The FortiGate cloud key added to the FortiGate cloud portal and FortiGate performs a factory reset before the restart

C. The zero-touch provisioning process completes internally, behind FortiGate

D. FortiDeploy connects with FortiGate and provides the initial configuration to contact FortiManager