2026년 현재 Fortinet NSE 7 - SD-WAN 7.0은 IT 인증 가운데서도 높은 관심을 받는 시험입니다. KoreaDumps의 NSE7_SDW-7.0 연습문제로 이 인기 자격에 도전해 보시기 바랍니다.

Fortinet NSE7_SDW-7.0 시험 개요:

Fortinet NSE7_SDW-7.0 시험 요강 주제:

NSE7_SDW-7.0 시험 준비, 자주 묻는 질문으로 정리했습니다

최신 NSE 7 Network Security Architect NSE7_SDW-7.0 무료샘플문제

문제 #1

Refer to the exhibit.

Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2.
Which two configuration settings are required for Toronto and London spokes to establish an ADVPN shortcut? (Choose two.)

A. auto-discovery-forwarder must be enabled on all IPsec VPNs.
B. On the spokes, auto-discovery-receiver must be enabled on the IPsec VPN to the hub.
C. On the hubs, net-device must be enabled on all IPsec VPNs.
D. On the hubs, auto-discovery-sender must be enabled on the IPsec VPNs to spokes.

문제 #2

Which two statements about the SD-WAN zone configuration are true? (Choose two.)

A. An SD-WAN member can belong to two or more zones.
B. The default zones are virtual-wan-link and SASE.
C. The service-sla-tie-break setting enables you to configure preferred member selection based on the best route to the destination.
D. You can delete the default zones.

문제 #3

What does enabling the exchange-interface-ip setting enable FortiGate devices to exchange?

A. The gateway address of their IPsec interfaces
B. The name of their IPsec interfaces
C. The IP address of their IPsec interfaces
D. The tunnel ID of their IPsec interfaces

문제 #4

Refer to the exhibit.

Based on the exhibit, which two actions does FortiGate perform on traffic passing through port2? (Choose two.)

A. FortiGate always blocks all traffic, after a route change.
B. FortiGate does not change the routing information on existing sessions that use a valid gateway, after a route change.
C. FortiGate performs routing lookups for new sessions only, after a route change.
D. FortiGate flushes all routing information from the session table, after a route change.

문제 #5

Refer to the exhibit.

Which statement explains the output shown in the exhibit?

A. FortiGate used 192.2.0.1 as the gateway for the original direction of the traffic.
B. FortiGate will not re-evaluate the session following a firewall policy change.
C. FortiGate must re-evaluate the session due to routing change.
D. FortiGate performed standard FIB routing on the session.

질문과 대답: