최신Juniper Enterprise Routing and Switching, Specialist (JNCIS-ENT) - JN0-349무료샘플문제

A. A keepalive message has been received.

B. The TCP connection is successful, and BGP is waiting for the OPEN message from its peer.

C. The BGP session is fully established and routes are being passed.

D. The routes are still trying to establish a TCP connection.

A. You must define all ports as trunk ports and include all VLANs as members.

B. You must configure a single logical IRB interface with an IP address for each of the three networks.

C. You must create a unique logical IRB interface for each network and assign an IP address within the appropriate network.

D. You must define all ports as access ports and include the appropriate VLAN as a member.

E. You must specify the appropriate Layer 3 IRB interface under each VLAN.

A. irb

B. ethernet-switching

C. inet

D. l3-interface

A. OSPFv3 uses the IPv6 address of the first interface that comes up.

B. OSPFv3 uses the IPv4 address of the first interface that comes up.

C. OSPFv3 uses the IPv4 address of the last interface that comes up.

D. OSPFv3 uses the IPv6 address of the last interface that comes up.

A. show bgp neighbor

B. show bgp summary

C. show bgp replication

D. show task replication

A. Enable level 1 IS-IS routing on Router A.

B. Enable IS-IS wide metrics on Router B.

C. Enable level 2 IS-IS routing on Router B.

D. Enable IS-IS wide metrics on Router A.

A. The graceful-restart capability will be disabled for group EBGP.

B. The graceful-restart capability will be disabled for group IBGP.

C. The graceful-restart capability will be enabled for group IBGP.

D. The graceful-restart capability will be enabled for group EBGP.

A. The OSPF RID is not necessary when BFD is implemented.

B. The OSPF RID for IPv6 is a 128-bit address.

C. The OSPF RID for IPv4 is a 32-bit address.

D. The OSPF RID must match for all routers in the same area.

A. Change the MED value for all routes received from ISP A to 1 while all routes from ISP B remain configured with no MED value.

B. Prepend the AS path to all routes received from ISP A while all routes received from ISP B use the default AS path value.

C. Set the local-preference attribute for all routes received from ISP A to 200 while all routes received from ISP B use the default local-preference value of 100.

D. Set the local-preference attribute for all routes received from ISP A to 50 while all routes received from ISP B use the default local-preference value of 100.

A. All of the above

B. Hitless key chain of MD5 keys/checksums

C. MD5 checksum

D. Simple password